I would not recommend blind scanning on these sats, you will get a lot of bleed over because they are so close together, best to check the frequencies on Flysat/Kingofsat and enter them manually, a little more trouble but you will avoid errors like you are experiencing. No I would leave the motor position, it sounds like you have it set pretty good.
Regards Mobley3
Results 21 to 24 of 24
|
|
-
Re: Multi LNB dish with motor diseqc 1.2Experienced Board Member
- Join Date
- Jun 2012
- Posts
- 693
- Thanks
- 133
- Thanks
- 174
- Thanked in
- 158 Posts
- Total Downloaded
- 0
10-11-2013, 04:27 PM
-
Re: Multi LNB dish with motor diseqc 1.2Administrator
- Join Date
- Feb 2010
- Posts
- 174
- Thanks
- 802
- Thanks
- 341
- Thanked in
- 98 Posts
- Total Downloaded
- 0
10-12-2013, 12:52 PM
I agree. Try turning LNB few degrees left or right.
It will help you very much with some transponders.
-
Multi LNB dish with motor diseqc 1 2Banned
- Join Date
- Jun 2019
- Location
- United Kingdom
- Posts
- 4
- Thanks
- 0
- Thanks
- 0
- Thanked in
- 0 Posts
- Total Downloaded
- 0
07-10-2019, 07:49 PM
Hi: I made a netinst installation debian-9.4.0-i386-netinst.iso without a network connection and as a concequence I only have a very basic install. How could I complete it now I am running the OS? apt-get?
-
Multi LNB dish with motor diseqc 1 2Newbie
- Join Date
- Jul 2019
- Location
- Panama
- Posts
- 7
- Thanks
- 0
- Thanks
- 0
- Thanked in
- 0 Posts
- Total Downloaded
- 0
08-07-2019, 01:41 AM
I did a clean installing of Knoppmyth 5.5. I can boot and use the system.
Due to some issues with video driver I need to install some more packages. I use apt but I receive several dependency problems:
Code:
| « Previous Thread | Next Thread » |