Notices
 
Results 1 to 5 of 5
  1. Collapse Details
     
    #1
    Senior Member
    Join Date
    Nov 2010
    Posts
    104
    Thanks Thanks Given 
    28
    Thanks Thanks Received 
    26
    Thanked in
    22 Posts
    Total Downloaded
    0
    need any special configuration to operate the satellite change? With the same cable and HD300 mvision net is properly Someone with you? and as it has solved thanks

    Nobody uses motor Gigablue hd solo?
    The same motor with the same settings in dreambox ok, in Gigablue ko, someone help me? thanks
     
     

  2. Collapse Details
    Re: problems with the motor 800 solo 
    #2
    Experienced Board Member bokkie's Avatar
    Join Date
    Feb 2012
    Posts
    1,505
    Thanks Thanks Given 
    104
    Thanks Thanks Received 
    479
    Thanked in
    381 Posts
    Total Downloaded
    0
    From my undrstanding the dish and motor are already installed and you just want to change the stb? All you should need to do is configure it to positioner in your settings, enter your longitude and latitude, and you should be good to go.
    If I helped, or if you like my post, please push thanks.[SIGPIC][/SIGPIC]
     
     

  3. Collapse Details
    Re: problems with the motor 800 solo 
    #3
    Junior Member
    Join Date
    Feb 2013
    Posts
    12
    Thanks Thanks Given 
    1
    Thanks Thanks Received 
    5
    Thanked in
    4 Posts
    Total Downloaded
    0
    I sometimes do not always worked I used: azbox engine sat tracer enigma 2. The engine sometimes wrong some satellites could take others not at the engine above the 21 east did not want to go
     
     

  4. Collapse Details
    Re: problems with the motor 800 solo 
    #4
    Senior Member
    Join Date
    Nov 2010
    Posts
    104
    Thanks Thanks Given 
    28
    Thanks Thanks Received 
    26
    Thanked in
    22 Posts
    Total Downloaded
    0
    that's not the problem is properly configured with decos as dreambox 800 works fine, the engine does not work well with 800solo being properly configured. latitude and longitude, so I want to know if anyone has the same problem as me, thanks
     
     

  5. Collapse Details
    Re: problems with the motor 800 solo 
    #5
    Senior Member
    Join Date
    Nov 2010
    Posts
    104
    Thanks Thanks Given 
    28
    Thanks Thanks Received 
    26
    Thanked in
    22 Posts
    Total Downloaded
    0
    nobody uses this deco? motor?
     
     

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •