Notices
 
Page 1 of 6 123 ... LastLast
Results 1 to 10 of 51
  1. Collapse Details
    CCcam Freezing Problems Explained 
    #1
    Member VasilisE's Avatar
    Join Date
    Apr 2010
    Posts
    66
    Thanks Thanks Given 
    10
    Thanks Thanks Received 
    234
    Thanked in
    26 Posts
    Total Downloaded
    0
    I had this topic in old forum but since most of my topic are gone with the server crash lets start this again .

    Freezing - some possible causes
    Most people who have been using CCcam servers for some time will have probably experienced freezing at some point.

    There are several things that will cause freezing, also remember you have no control over what is happening on the server you are connected to. A lot of the problems come from the other end.

    Firstly, when you allocated your router ports, set them for TCP/UDP.
    You can test if the ports are opening by going here:

    http:// www. amule.org/testport.php

    Common causes are:

    Your internet connection is slow. Check your ping times and DONT download torrents at the same time when viewing - sharing with CCcam.

    The person you are connected to has slow internet connection. By this i mean not only the speed but the response time as well ( witch is more critical than speed itself ) .

    You have the same C Line active in more than one receiver
    You can't do that. Think it as making a call with several persons to answer in the other side ....

    You have two different C lines to two different servers - both supplying the same card.
    This can cause problems. Test and find with witch you have the better performance and block the other card.

    You are receiving the same card on hop1 & hop2 etc..
    Filter the hop2's out.

    The server is overloaded at the other end.
    The most common cause of them all .An overloaded hop1 server can cause your file to connect to a Hop2 instead - but then keeps trying to get back on the hop1.

    Because a guys card shows you hop1 - it does NOT mean it is hop1 - or he even has a card. There are methods of faking this - and a lot out there doing it. Try another server with the same card to compare.

    Some hop2's can be faster than some hop1's - filter them out.

    Your Ccam config is not optimized.
    Look at my other post regarding cccam.cfg

    Your dish is not tuned correctly to the sat.


    Some people will not accept a connection that is slower than 100ms. If a connection is around 400ms - it is quite possible that person does not have the relevant card.

    Certain cards freeze/glitch if the other persons file is not set up correctly.

    As mentioned above, you have no control over the set up at the other end. Sometimes you have to try several sources to test for a reliable server.
    Proud owner of DM800 - DM600 -DM500 - Humax5400 IRCI - Nokia 9600

    I post only what i have used and tested myself .....
     
     

  2. The Following 33 Users Say Thank You to VasilisE For This Useful Post:

    aberdojde (07-12-2011), acyacy (02-13-2011), adn3dz (10-06-2010), afest (08-25-2012), aliasa65 (05-05-2012), anacondama (09-16-2010), bong1 (06-21-2010), coucou152 (02-12-2012), dodgy2 (12-10-2011), findeciclo (10-08-2010), hadibadi (03-13-2012), irdeto1 (05-16-2012), Jerry2020 (06-21-2010), jolatacqce (05-31-2011), Konani (09-22-2010), lothar27 (07-13-2011), mbensalah (12-26-2011), meyes (10-23-2010), mohpower (08-09-2012), moschnitnt (09-14-2012), nacer1963 (01-06-2011), redrage (02-10-2013), ROKH (03-22-2011), runmo (06-28-2010), sam007 (06-21-2010), sasho123 (03-13-2012), SatWaveDude (08-23-2012), seb131 (09-25-2010), stewie (09-22-2010), Triad (03-13-2012), unsuspicious (08-17-2011), yurad (02-26-2011), z774c90 (12-29-2010)

  3. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #2
    Banned
    Join Date
    Feb 2010
    Posts
    0
    Thanks Thanks Given 
    38
    Thanks Thanks Received 
    20
    Thanked in
    18 Posts
    Total Downloaded
    0
    Also some providers work better or some encryption systems than others
     
     

  4. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #3
    Member VasilisE's Avatar
    Join Date
    Apr 2010
    Posts
    66
    Thanks Thanks Given 
    10
    Thanks Thanks Received 
    234
    Thanked in
    26 Posts
    Total Downloaded
    0
    Quote Originally Posted by Jerry2020 View Post
    Also some providers work better or some encryption systems than others
    True .
    NDS for example needs fast ECM times while Viaccess doesnt
    Proud owner of DM800 - DM600 -DM500 - Humax5400 IRCI - Nokia 9600

    I post only what i have used and tested myself .....
     
     

  5. The Following User Says Thank You to VasilisE For This Useful Post:

    adn3dz (10-06-2010)

  6. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #4
    Board Senior Member bong1's Avatar
    Join Date
    Apr 2010
    Posts
    202
    Thanks Thanks Given 
    53
    Thanks Thanks Received 
    18
    Thanked in
    17 Posts
    Total Downloaded
    0
    using less servers is also better i thought when i started more was better but it creates more freezing nice tut thanks
    coyi !
     
     

  7. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #5
    Member VasilisE's Avatar
    Join Date
    Apr 2010
    Posts
    66
    Thanks Thanks Given 
    10
    Thanks Thanks Received 
    234
    Thanked in
    26 Posts
    Total Downloaded
    0
    The trick isn't to have a lot of cards but having stable and fast ones. Filter out the crap ...
    Proud owner of DM800 - DM600 -DM500 - Humax5400 IRCI - Nokia 9600

    I post only what i have used and tested myself .....
     
     

  8. The Following User Says Thank You to VasilisE For This Useful Post:

    moschnitnt (09-14-2012)

  9. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #6
    Member VasilisE's Avatar
    Join Date
    Apr 2010
    Posts
    66
    Thanks Thanks Given 
    10
    Thanks Thanks Received 
    234
    Thanked in
    26 Posts
    Total Downloaded
    0
    The things you can do are : Good and clean cccam.cfg and a fast response internet line. As for the plugin i am not using it and still i have no issues ...
    Proud owner of DM800 - DM600 -DM500 - Humax5400 IRCI - Nokia 9600

    I post only what i have used and tested myself .....
     
     

  10. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #7
    Banned
    Join Date
    Jul 2010
    Posts
    656
    Thanks Thanks Given 
    79
    Thanks Thanks Received 
    183
    Thanked in
    129 Posts
    Total Downloaded
    0
    Quote Originally Posted by VasilisE View Post
    You have two different C lines to two different servers - both supplying the same card.
    This can cause problems. Test and find with witch you have the better performance and block the other card.

    You are receiving the same card on hop1 & hop2 etc..
    Filter the hop2's out.
    can you explain more how to do this operation and how to know what is the better source for supplying cards please??
     
     

  11. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #8
    Member
    Join Date
    Feb 2010
    Location
    Bucharest
    Posts
    79
    Thanks Thanks Given 
    8
    Thanks Thanks Received 
    47
    Thanked in
    5 Posts
    Total Downloaded
    0
    Quote Originally Posted by VasilisE View Post
    The trick isn't to have a lot of cards but having stable and fast ones. Filter out the crap ...
    good point but how can we filter out the crap?
     
     

  12. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #9
    Experienced Member tonybod's Avatar
    Join Date
    Apr 2010
    Posts
    376
    Thanks Thanks Given 
    90
    Thanks Thanks Received 
    238
    Thanked in
    136 Posts
    Total Downloaded
    0
    Quote Originally Posted by gaivan View Post
    good point but how can we filter out the crap?
    Use the cccam.channelinfo, cccam.prio and cccam.providers files. Beyond that I am not sure what you can do as a client. You can specify that you only want a certain card and ignore others from a single server, but if that server has two copies of the same card, I've got no idea how you go about selecting between the two of them.

    Tony.
    Technomate TM600 + 1m motorised dish (TM2300 motor).

    If you find my posts helpful, please press the thanks button.


    Some useful links.
    Freezing problems explained

    Cccam prio files.

    Cccam channelinfo files.

    Forum rules
     
     

  13. Collapse Details
    Re: CCcam Freezing Problems Explained 
    #10
    Board Senior Member seb131's Avatar
    Join Date
    Jun 2010
    Posts
    348
    Thanks Thanks Given 
    10
    Thanks Thanks Received 
    117
    Thanked in
    83 Posts
    Total Downloaded
    0
    Interresting.
    How do you filter he hops ? Can we know what are the providers available on a server and on each hop? Is there a tool ?
    When we have access to several satlover servers, do we need to cut off the line and to keep only one ?
    If you find this post usefull, please hit the thanks button !
    ______________________________
    dm800 clone, dm7000, BisTv & Csat
     
     

  14. The Following User Says Thank You to seb131 For This Useful Post:

    jonjon (06-21-2011)

Page 1 of 6 123 ... LastLast
Tags for this Thread

View Tag Cloud

 
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •